Browse Category

Water Heater Repair

Fort Collins Water Heater Installation – The Easy Way

When all you have to do is switch out your current water heater, it may seem like a simple swap. On the surface, however, it is not that simple: You disconnect the old water tank, unplug the gas line, unplug the heater from the wall, move everything back to the beginning of the tank, plug in the new tank, and finally attach the heater to the wall. You may want to check out Fort Collins Water Heater Pros – Fort Collins water heater installation for more.

If you are inexperienced with basic water heater installation, this process can be very intimidating. If you are working on a small budget, you may want to hire a handyman or plumber to complete the job for you. This will help you save time and money, but it is not something that should be done by yourself.

Before you even consider this step, make sure that you are equipped with the proper tools and supplies that will ensure your safety. For starters, make sure that you have a pair of heavy gloves to protect your hands. Gloves are also a great idea if you are going to be touching any of the equipment, because water and other chemicals can be deadly if they are absorbed into the skin. Also, it is important that you wear a respirator when doing this work.

The next step in this process is to get all the basic tools that you need for the job. You will need a screwdriver, drill, saw, and measuring tape. You may also need a bucket, ladder, and jack for this project.

If you are going to connect your water supply to the tank to which your heater has been disconnected, make sure that you have some type of connection between the two tanks. This connection needs to be made before you install the tank and water heater. In order to make the connection, unscrew the two screws in the bottom of the tank and insert a wrench the screwdriver into one side of the hole and slowly pull it out. You will have to use pliers to keep the screwdriver from going all the way out of the tank. After that, attach the connection with more screws and put the screws back into the tank.

The last step is putting the tank on to the wall and placing the water tank over the water supply. This is where the fun part starts – putting in the water supply and turning on the heater to test it out.